Blog – Page 2 – Projectkitsandparts

29 Jun

Load Cell Measurement using Arduino

Introduction In this project, we will build a system to measure the weight or force applied to a load cell using an Arduino microcontroller. The load cell will convert the applied force into an electrical signal, which will be amplified and processed by the Arduino. We will display the measured weight on an LCD screen. … Read more

27 Jun

Interfacing 1-Key Input Button to Control 1-LED

Project Overview: In this project, we will demonstrate how to interface a 1-key input button with an Arduino board to control the ON/OFF state of an LED. Each button press will toggle the LED’s state. Hardware Required: Circuit Diagram: Connect the components as follows: Note: The specific pin connections may vary depending on the type … Read more

26 Jun

Interfacing DC-Motor with Arduino Board

In this project, we will demonstrate how to interface a DC motor with an Arduino board. The Arduino will control the motor’s rotation direction. Hardware Required: Circuit Diagram: Connect the components as follows: Note: The motor driver module (e.g., L293D) is used to control the direction and speed of the DC motor. The specific connection … Read more

25 Jun

Interfacing Buzzer with Arduino Board

In this project, we will demonstrate how to interface a buzzer with an Arduino board. The buzzer will be used to generate sound or alert signals based on the Arduino’s control. Hardware Required: Circuit Diagram: Connect the components as follows: Connection Table: Here’s a connection table for the buzzer and Arduino: Buzzer Arduino Board Buzzer … Read more

24 Jun

Interfacing Relay Module with Arduino

In this project, we will demonstrate how to interface a relay module with an Arduino board. A relay module is an electrical switch that allows low-power microcontrollers like Arduino to control high-power devices such as motors, lights, or appliances. We will control the relay module using Arduino and switch an external device on and off. … Read more

23 Jun

Interfacing a Single LED with Arduino Board

In this project, we will demonstrate how to interface a single LED (Light Emitting Diode) with an Arduino board. The Arduino board will be programmed to control the LED and make it blink at a specific rate. Hardware Required: Circuit Diagram: Connect the components as follows: Connections: Arduino Uno Led Module 5v Vcc(5v) Digital … Read more

22 Jun

Arduino IDE 2.1 installation on Windows

There is a new version of Arduino IDE called Arduino IDE 2.1.(beta). This tutorial will guide you through the process of installing ESP8266 boards in Arduino IDE 2.1 and uploading code to the board. The tutorial is compatible with Windows operating systems. Go to the www.arduino.cc/en/software Find Arduino IDE 2.1.0 setup Click … Read more

Login

Register

Cookies Notice